Increase productivity fired boiler for greenhouse system must first be optimized for verification, including the entire steam system for a complete analysis, and focus on some of the energy waste places. Via check can often find opportunities to save energy, increase productivity, and environmental protection have a positive contribution of. Check includes a steam generation, distribution, use and condensate recovery. The main steam waste requiring special attention place: exhaust gas boiler: boiler efficiency emissions system the most important indicators, the loss of energy is the most important place. Combustion air: general air enters the combustion furnace of the genus room temperature, require a lot of heating energy, i.e., the most commonly used power saving mode using a high temperature exhaust gas to preheat the combustion air of boiler, boiler efficiency can be significantly improved. The fuel / air ratio: Proper oil / gas mixture can only complete combustion, if the lack of air, combustion is incomplete, not only smoky pollution, environmental protests caused nearby residents, and easy carbonized grease gun and boiler heating tubes affect performance. If excess air is formed wasted energy, reducing boiler efficiency. Via the oxygen content of the tail gas can appropriately adjust the oil / gas ratio. Oil-fired boiler exhaust gas which content 3%, i.e., the excess air of about 15%, as the standard combustion control.
As the "Star Pavilion" on the show, the arrival of fast fired boiler for greenhouse is attracted quite a stir. Guests and friends from all over the world friends are gathered in front of "fast Boiler" booth, feeling the charm to bring clean boiler. This is the third appearance in the fast side of the trade show, our booth set up in the middle of the field, in the light against the background, beautiful booth set off for the scene of different merchants brought extraordinary appeal.
Gas-fired center fired boiler for greenhouse reminds you to shut off the fuel supply of the furnace immediately in case of quenching, close the electromagnetic valve for gas supply (oil and return), and then close the fuel supply valve for the operation of burners. Operate quickly so as not to cause a vicious risk when fuel continues or resumes supply. At the same time, find out the causes of boiler quenching, remove the found faults, and make preparations for restarting.
2, tightness test
Indoor gas boiler pipes tightness test should be consistent with the following requirements:
① low pressure gas pipe test pressure boiler for planning a pressure not less than 5kPa, under the experimental pressure regulator least 30min, and view all the joint with the blowing agent, no leakage, no pressure gauge pressure drop qualified equipment. When the experimental system stainless steel corrugated hose, plastic composite pipe, oil hose, when the plastic cover brass, IH pressure not less than the experiment, in addition to sealing the respective view point, the end surface of the cladding layer should also whether there is leakage phenomenon View.
② medium pressure gas pipelines boiler pressure test planning more pressure and not less than 0.1Mpa. Under the experimental pressure regulator less than 2h, and view all joints with a blowing agent, no leakage, no pressure drop pressure measurement device qualified.
